Dies for Metric Rhinestones and Nailheads. Top Loading MDT

This die has a 4MM rubber sleve at the top which holds the ornament by friction. This allows for right-side-up working. The size of the ornament should be equal to the sleve size, or up to 0.25mm oversize.

This die has a 4.5MM rubber sleve at the top which holds the ornament by friction. This allows for right-side-up working. The size of the ornament should be equal to the sleve size, or up to 0.25mm oversize.

This die has a 5MM rubber sleve at the top which holds the ornament by friction. This allows for right-side-up working. The size of the ornament should be equal to the sleve size, or up to 0.25mm oversize.

This die has a 5.5MM rubber sleve at the top which holds the ornament by friction. This allows for right-side-up working. The size of the ornament should be equal to the sleve size, or up to 0.25mm oversize.

This die has a 6MM rubber sleve at the top which holds the ornament by friction. This allows for right-side-up working. The size of the ornament should be equal to the sleve size, or up to 0.25mm oversize.

This die has a 6.5MM rubber sleve at the top which holds the ornament by friction. This allows for right-side-up working. The size of the ornament should be equal to the sleve size, or up to 0.25mm oversize.

This die has a 7MM rubber sleve at the top which holds the ornament by friction. This allows for right-side-up working. The size of the ornament should be equal to the sleve size, or up to 0.25mm oversize.

This die has a 7.5MM rubber sleve at the top which holds the ornament by friction. This allows for right-side-up working. The size of the ornament should be equal to the sleve size, or up to 0.25mm oversize.

This die has an 8MM rubber sleve at the top which holds the ornament by friction. This allows for right-side-up working. The size of the ornament should be equal to the sleve size, or up to 0.25mm oversize.

This die has an 8.5MM rubber sleve at the top which holds the ornament by friction. This allows for right-side-up working. The size of the ornament should be equal to the sleve size, or up to 0.25mm oversize.

This die has a 9MM rubber sleve at the top which holds the ornament by friction. This allows for right-side-up working. The size of the ornament should be equal to the sleve size, or up to 0.25mm oversize.

This die has a 9.5MM rubber sleve at the top which holds the ornament by friction. This allows for right-side-up working. The size of the ornament should be equal to the sleve size, or up to 0.25mm oversize.

This die has a 12.5MM rubber sleve at the top which holds the ornament by friction. This allows for right-side-up working. The size of the ornament should be equal to the sleve size, or up to 0.25mm oversize.

This die has a 14.5MM rubber sleve at the top which holds the ornament by friction. This allows for right-side-up working. The size of the ornament should be equal to the sleve size, or up to 0.25mm oversize.